Repairing defects such as scratches, scratches, yellowing, aging, blurring, cracking, etc. on plastic headlights
Description of operation steps
(1) Grinding is done with 320#-600#-1000# sandpaper and water until the water is milky white. Then use 2000# sandpaper and water to polish until the surface is smooth and clean.
(2) Open the bottle, pour 60ml of repair solution. Then power on.
(NOTE:Due to the liquid in the factory bottle, the customs can not pass, so the liquid is poured out before delivery, we do not charge the liquid, not the second use, 100% brand new.)
If you want to buy repair liquid , please click this link
(3) Connect the spray tube and connect the vehicle or household power supply.
(4) After atomization coating is energized for 2 minutes, the spray port is 1 centimeters away from the lamp surface.When operating, the brightness can be plated.
（Do not coat the same place for a long time, so as not to affect the drying speed.）
Attention OPERATION STEPS
1. It should be completely polished off the original coating on the lamp surface, not polished completely on the lamp surface can not be coated.
2. It is necessary to pour repair solution, then to connect the power supply.
3. When operating, the tank can not be tilted to more than 75 degrees. And prevent fog from dropping.
4. When the ambient temperature is below 20 ~C, heating the lamp to 50 ~C with a baking lamp or a hairdryer, or heating the lamp for 10 minutes before coating
5. When the coating solution is used up, please disconnect the power supply when the power indicator flashes.
6. Please wear protective glasses mask for good ventilation. If the film is splashed into the eyes, rinse immediately with plenty of water. If you accidentally inhaled steam, please move to the fresh air quickly and keep the airway open.
Rated voltage: 220V
1× Atomized cup
1× Atomizing nozzle